Ribbon Saving Module (B-4905-R-Qm) - TEC B-470 SERIES Maintenance Manual

3. INSTALLATION PROCEDURE FOR THE OPTIONAL EQUIPMENT
Expansion memory and drawing size
RAM
Applicable
Capacity
Type
512KB
Old CPU PC
Board
(Ref. No.
1MB
0Dxxxxxx
or earlier)
NEW CPU PC
2MB
Board
(Ref. No.
0Exxxxxx
or later)
NOTE: Addition of the D-RAM can expand the memory of the old CPU PC board up to 1MB, however,
the expansion of the memory module is not required for the new CPU PC board, which is equipped
with the 2MB memory as standard.

3.4 Ribbon Saving Module (B-4905-R-QM)

Description
Ribbon Saving Module
1. Turn the head lever counterclockwise to release the ribbon shaft holder plate.
2. Remove the ribbon stopper from the ribbon shaft on which the ribbon is wound. Before removing the
ribbon stopper, check its attaching direction for later installation. Remove the ribbon stopper from the
ribbon shaft on which the ribbon is wound.
3. Remove the two SM-4 x 8 screws to detach the solenoid attaching plate.
Solenoid Attaching Plate
Max. drawing size (normal)
(W) x (H) (mm)
Batch Strip Auto-cut
104.0 x 384.0
104.0 x 896.0
104.0 x 896.0
Q'ty/Unit
1
Print Block
Max. drawing size (on-the-fly)
(W) x (H) (mm)
Batch Strip
104.0 x 192.0
104.0 x 448.0
104.0 x 448.0
Screw (SM-4x8B)
3-6
(Revision Date: Feb. 10, 2000)
3.4 Ribbon Saving Module (B-4905-R-QM)
Remarks
Auto-cut
Standard
((IC21)
Option
(IC21,22)
Standard
(IC19)
Ribbon Shaft
Ribbon Stopper
Fig. 3-9
EM18-33011