Process Test Print - TEC B-680 SERIES Maintenance Manual

6. DIAG. TEST OPERATION

6.4.2 Process Test Print

In the process test print, the test print is automatically performed under the following conditions.
Parameter setting and print tone fine adjustment value is ignored.
• OPERATION :
• ISSUE COUNT :
• PRINT SPEED :
• SENSOR :
• RIBBON :
• TYPE :
• LABEL LENGTH : 76 mm
• PRINT TONE FINE ADJUSTMENT VALUE :+0
Operating procedure for the test mode is provided below.
From on
C
the next page.
Press the [RESTART]
key.
To of the
A
preceding page.
One label feed, 3-dot slant line print, bar code print, character print
5 labels each
8 inches/sec.
Transmissive sensor (feed gap sensor) or reflective sensor (black
mark sensor)
Transmissive ribbon
Batch (without cut)
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
< 1 > D I A G N O S T I C
Press the [FEED] key twice.
< 3 > T E S T P R I N T
Press the [PAUSE] key.
P R I N T C O N D I T I O N
Press the [RESTART] key.
After feeding one label, slant
lines (3 dots) are printed on 5
labels.
P R I N T ( R E F L E
A U T O
Press the [PAUSE] key.
[Bar codes are printed on 5 labels.]
To be continued on
of the next page.
B
V 1 . 0 A
C T . )
6-60
EO18-33006
6.4 TEST PRINT MODE
Press the [FEED] key
and [RESTART] key
at the same time.
To of the
C
preceding page.