Strip Wait Status Selection - TEC B-680 SERIES Maintenance Manual

6. DIAG. TEST OPERATION

6.3.20 Strip Wait Status Selection

Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
< 1 >
D I A G N O S T I C
Press the [FEED] key.
< 2 >
P A R A M E T E R
Press the [PAUSE] key 22 times.
S T A
T U S
Press the [FEED] or
[RESTART] key to select
the strip wait status.
(See NOTE 1.)
Press the [FEED]
and [RESTART] key
at the same time.
NOTES: 1. Holding the [FEED] key or [RESTART] key down for more than 0.5 seconds enables a
fast forward.
2. When the status type 1 is selected, the printer will send (00H) in response to the status
request command sent from the PC while a label stays at the strip sensor (when idling,
after feeding, or all printing finished).
When the status type 2 is selected, the printer will send (05H) in response to the status
request command sent from the PC while a label stays at the strip sensor (when idling,
after feeding, or all printing finished.)
If the status request command is sent during printing, the printer will always send (05H)
regardless of the setting.
Power off
1 . 0 A
V
S E T
T Y P E
Press the [PAUSE] key.
Continued on Section 6.3.21
Feed key Function Selection.
[FEED] key:
Status type 2: A strip wait status is sent.
1
[RESTART] key:
Status type 1: A strip wait status is not sent.
6-42
EO18-33006
6.3 PARAMETER SETTING MODE