Table of Contents
Advertisement
3. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
3.2 STRIP MODULE (B-4908-H-QM)
NOTE:
This module cannot be used together with the B-4208-QM cutter module. Remove the cutter
module if it has been attached to the printer.
D
e
c s
S
r t
p i
U
n
t i
S
r t
p i
H
a
n r
1) Open the right side cover and the top cover. (See Fig. 2-1)
2) Remove the left side cover (See Fig. 2-1)
3) Remove the front plate (See Fig. 2-5)
4) Remove the operation panel (See Fig. 3-1)
5) Connect the strip harness to the CN2 on the PWM PC board through the opening of the strip base.
6) Install the strip unit to the printer with the four FL-4 x 6 screws removed in STEP 3.
7) Connect the strip harness to the CN4 on the I/O PC board.
8) Connect the strip sensor harness to the CN15 on the I/O PC board.
I/O PC Board
CN15
CN4
Strip Harness
9) Mount the operation panel and the left side cover on the printer.
10) Close the top and right covers.
11) Refer to Section 6.4 of the Maintenance Manual to load the label and make a test print to check
forproper strip issue. If not, refer to Section 6.3.2 of the Maintenance Manual to adjust the strip
position.
i r
t p
o i
n
Q
y t '
U /
n
1
e
s s
1
Screw (FL-4 x 6)
Screw (FL-4 x 6)
Strip Unit
Strip Sensor Harness
t i
PWM PC Board
Strip Base
Screw (FL-4 x 6)
3-4
3.2 STRIP MODULE (B-4908-H-QM)
Strip Harness
CN2
Opening
Fig. 3-6
EO18-33006
Advertisement
Chapters
Table of Contents
