TEC B-680 SERIES Maintenance Manual page 87

6. DIAG. TEST OPERATION
From of the
A
preceding page.
NOTES: 1. When there is no change to the print condition, select one of the test print options to issue
the test print.
2. Holding the [FEED] key or [RESTART] key down for more than 0.5 seconds enables a fast
forward.
3. A selected print condition is activated when the [PAUSE] key is pressed.
4. When the feed gap sensor is selected, the gap between labels becomes 3mm long.
5. A label size greater than the image buffer length cannot be designated. The image buffer
length differs according to memory size. If designated, the printer prints in the image
buffer, or the printer stops because of an error.
6. Pressing the [FEED] key changes the label length -1 mm, pressing the [RESTART] key
changes +1 mm.
7. When an error occurs during a test print, the error message is displayed and printing is
stopped. The error is cleared by pressing the [PAUSE] key and the display shows "<3>
TEST PRINT". Printing is not automatically resumed after the error is cleared.
8. When the space area is 20mm at the print speed of 3"/sec., and 8"/sec., the printer
automatically enters ribbon saving print mode. (only when the ribbon saving module is set
to ON at the thermal transfer print)
From of the preceding page.
B
< 3 > T E S T P R I N T
Press the [PAUSE] key.
N T C O N D I T I O N
P R I
Select the test print from
those at the right by
pressing the [FEED] key
or [RESTART] key.
A designated number of
test prints are issued when
pressing the [PAUSE] key.
(See NOTE 8.)
< 3 > T E S T P R I N T
Press the [PAUSE] key.
SLANT LINE (1 DOT)
SLANT LINE (3 DOT)
CHARACTERS
BAR CODE
NON-PRINTING
FACTORY TEST PATTERN
Process test line print
AUTO PRINT (TRANS.) :
Process test print/Transmissive sensor
AUTO PRINT (REFLECT.) :
Process test print/Reflective sensor
6-57
EO18-33006
6.4 TEST PRINT MODE
Press the [FEED] key
and [RESTART] key at
the same time.