Table of Contents
Advertisement
Figure 22 Connecting the power adapter
Verifying the installation
After you complete the installation, verify that:
There is enough space around the router for heat dissipation.
•
The router is mounted securely on the wall or on a sturdy workbench.
•
Antennas, USB devices, and interface modules are installed correctly.
•
The router and power module are grounded properly.
•
The power supply meets requirements.
•
The router is connected correctly to the console terminal and other devices; parameters are
•
configured correctly on the console terminal.
Before starting up the router, set up the console terminal as described in
cable and setting terminal
for the router.
Powering on the router
WARNING!
Before powering on the router, locate the power source switch so that you can cut off power promptly
in case of an emergency.
Switch on the power source.
•
Turn on the power switch on the router.
•
Startup process
After power-on, the router initializes its memory, and then runs the extended BootWare. The console
terminal screen displays the following:
System is starting...
Do you want to check SDRAM? [Y/N]
Booting Normal Extend BootWare
The Extend BootWare is self-decompressing........................Done!
parameters." Then, power on the router and perform initial configuration
22
"Connecting the console
Advertisement
Table of Contents
