This feature allows the dispatcher to temporarily reassign
selected radios to a single special channel so they can
communicate with each other. This feature is typically used
during special operations and is enabled by a qualified radio
technician.
You will not notice whether your radio has this feature enabled
until a dynamic regrouping command is sent by the dispatcher.
If you try to access a zone or channel that has been
reserved by the dispatcher as a dynamically regrouped
mode for other users, an invalid tone sounds.
1 When your radio is dynamically regrouped, it automatically
switches to the dynamically regrouped channel. A "gurgle"
tone sounds and the display shows the dynamically
regrouped channel's name.
2 Press the button to talk. Release button to listen.
When the dispatcher cancels dynamic regrouping, the radio
automatically returns to the zone and channel that you were
using before the radio was dynamically regrouped.
Requesting a Reprogram
This feature lets you notify the dispatcher that you want a new
dynamic regrouping assignment.
Press the preprogrammed button to send
reprogram request to the dispatcher and proceed to Step 3.
Follow the procedure below.
1
or
(on the keypad mic.) to
2 Press the button directly below
reprogram request to the dispatcher.
3 The display shows
4 If you hear five beeps, the dispatcher has acknowledged the
reprogram request. The display shows
the radio returns to the Home screen.
If the dispatcher does not acknowledge the reprogram
request within six seconds, a low-pitched alert tone sounds
and the display shows
Try again or press
to cancel and return to the Home
screen.
.
to send
and
.
and
.