Start Zero Calibration; Start Initialization; Restarting The Actuator (Reset); Loading Default Settings - Samson 3374 Mounting And Operating Instructions

Diagnostic level

15.3 Start zero calibration

WARNING!
Risk of injury due to the actuator stem extending or retracting!
Do not touch or block the actuator stem!
The actuator stem moves to the 0 % end position. Following this, the actuator changes to
closed-loop operation and moves the actuator stem to the position defined by the input sig-
nal.
Code Description
d51 Start zero calibration

15.4 Start initialization

The procedure is described in section 12.3 on page 33.

15.5 Restarting the actuator (reset)

The actuator can be restarted by performing a reset. Upon restart, the actuator goes into the
automatic mode unless a different restart condition has been defined. Refer to section 13.9
on page 45.
Code Description
d53 Perform reset

15.6 Loading default settings

All the parameters of the configuration level can be reset to their default settings (WE).
Note:

To load the default settings by selecting Code d54, the key number needs to be en-
tered beforehand (refer to section 11 on page 29).
Code Description
d54 Loading default settings
54
Adjustment range
ZER
Adjustment range
RES
Adjustment range
DEF
EB 8331-4 EN