Starting Zero Calibration; Starting Initialization; Restarting The Actuator (Reset) - Samson 3374-10 Mounting And Operating Instructions

Service level

11.2 Starting zero calibration

WARNING
!
Risk of injury due to the actuator stem extending or retracting.
Do not touch or block the actuator stem.
The actuator stem moves to the 0 % end position. Following this, the actuator changes to
closed-loop operation and moves the actuator stem to the position defined by the input sig-
nal.
Code Description
d51 Start zero calibration
Î Zero calibration can be canceled at all times by selecting ESC.

11.3 Starting initialization

WARNING
!
Risk of injury due to the actuator stem extending or retracting.
Do not touch or block the actuator stem.
Î The procedure is described in section 8.3 on page 44.
Code Description
d52 Start initialization
Î Initialization can be canceled at all times by selecting ESC.

11.4 Restarting the actuator (reset)

The actuator can be restarted by performing a reset. Upon restart, the actuator goes into the
operating mode previously set unless a different restart condition has been defined (see sec-
tion 9.9 on page 57).
Code Description
d53 Perform reset
68
Adjustment range
ZER
WE Adjustment range
INI
Adjustment range
RES
EB 8331-4 EN