Hach EC1000 Instruction Manual page 26

Example—changing ALARM2, SET PoiNT from 16.00 pH to 7.50 pH:
1. First move to the
ALARM2
Around the Menu. Press
2. Press the
RIGHT ARROW
3. Press the
DOWN ARROW
4. Press the
RIGHT ARROW
5. Press the
UP ARROW
6. Press the
RIGHT ARROW
7. Press the
UP ARROW
8. Press to save the new value.
ENTER
The second type of setup data is discrete values such as the recorder mode where a pH,
mV, or temperature recorder mode is selected. In this case, the complete entry flashes.
Pressing the or
UP DOWN ARROW
the desired entry, press the
Example—changing ALARM2, MODE from a PH HI alarm to TEMP LOW alarm:
1. Select ALARM2, MODE as described in Section 2.1.1 Moving Around the Menu.
Press .
ENTER
2. Press the
DOWN ARROW
3. Press to save the new value.
ENTER
set point entry as described in Section 2.1.1 Moving
.
ENTER
key to move the flashing digit to the right.
key to change the 1 to 0.
key to move to the next digit.
key to change the 6 to 7.
key to move to the next digit.
key five times to change the 0 to 5.
key scrolls through the list of settings. After selecting
key to save the setting.
ENTER
key five times to select the TEMP LOW alarm setting.
26