Table of Contents
Advertisement
16
4.3 USER INTERFACE
Activate the USER INTERFACE menu.
If a password is set in YOUR PASSWORD, a password is needed to continue. Enter the password set in YOUR PASS-
WORD and press the control knob.
The display will now show the following submenus:
• SHOW°C
• DISPLAY CONTRAST
• BACKLIGHT TIME
• BUTTON CLICK
• PROGRAM END BUZZER
General for all parameters/settings/values:
Save = Long press
Edit = Turn/Press
Exit = Long press/Double press
If there is a changeable value, the lowest and highest values that can be set are listed below the changeable value.
4.3.1
SHOW°C
Set if all the temperature values shall be displayed in °C or °F.
YES = Displayed in °C
NO = Displayed in °F
4.3.2
DISPLAY CONTRAST
Set the contrast value of the display.
The contrast of the display can be adjusted to adapt to the prevailing light in the room.
The pre-set value is 57.
4.3.3
BACKLIGHT TIME
Set the time that will pass before the display will reduce the backlight illumination.
The time can be set in minutes and seconds.
The pre-set value is 30 seconds.
4.3.4
BUTTON CLICK
Set if the machine shall give a sound for each new position when the buttons on the control panel/control knob is
pressed/turned or not.
YES = Sound
NO = No sound
4.3.5
PROGRAM END BUZZER
Set the time that the buzzer shall beep when a program has ended.
The time can be set in hours, minutes and seconds.
The pre-set value is 10 seconds.
0 = No beep
4.4 MACHINE ADDRESS
Set the address of the machine if the machine is to be connected in a network.
The pre-set value is 000.
Programming and Configuration Manual
Hide quick links:
Advertisement
Table of Contents
