Process Menu; Process Menu Time; Inactive Timeout; Regret Time - Electrolux Compass Pro Programming And Configuration Manual

Programming and Configuration Manual
31
RESET TO FACTORY
A password is needed to continue. The display will now show an eight figure code. Call authorized service and state
the code. Authorized service will assign a pass code. Enter the pass code you have been given and press the control
knob.
When activating RESET TO FACTORY all settings will be reset to factory settings.
TOTAL RESTORE
A password is needed to continue. The display will now show an eight figure code. Call authorized service and state
the code. Authorized service will assign a pass code. Enter the pass code you have been given and press the control
knob.
When activating TOTAL RESTORE all settings — menu settings as "coin values" etc will be deleted.

4.11 PROCESS MENU

Activate the PROCESS MENU menu.
The display will now show the following submenus:

• PROCESS MENU TIME

• INACTIVE TIMOUT

• REGRET TIME

• PAUSE PERMITTED

• PAUSE TIME
• NEW PROG. SELECT
• ABORT PROG. ALLOW
• SHOW STATISTICS
• STATUS MENU
• ALLOWED SPEED CHANGE
• PROCESS MENU PAUSE
4.11.1 PROCESS MENU TIME
The PROCESS MENU is the menu that appears on the display when pressing the control knob (start button on ma-
chines without control knob) in the user interface during operation.
Set the time that it is possible to activate the PROCESS MENU during a program run.
Default value is set to 24 hours, which means that it always is possible to activate the menu.
If for example the time is set to 10 minutes it is only possible to activate the menu during the 10 first minutes of a pro-
gram run.
The time can be set in hours, minutes and seconds.

4.11.2 INACTIVE TIMEOUT

Set the time that the PROCESS MENU will be displayed before disappearing if inactive.
The time can be set in hours, minutes and seconds.
4.11.3 REGRET TIME
Set the time that some menus will be displayed for in the PROCESS MENU before disappearing.
When regret time is up the function will be blocked.
For example: Pause function shall only be possible during the 10 first minutes of the program run = Set the time to 10
minutes.
The time can be set in hours, minutes and seconds.
4.11.4 PAUSE PERMITTED
Set the desired function for the sub-menu PAUSE in the PROCESS MENU in the user interface.
ON = It is possible to activate PAUSE during the time set in PROCESS MENU.
OFF = The sub-menu will not be displayed in the PROCESS MENU.
REGRET TIME = It is possible to activate PAUSE during the time set in REGRET TIME.