Your Password; I/O Configuration; List All I/O Boards; Setup All I/O Boards - Electrolux Compass Pro Programming And Configuration Manual

4.5 YOUR PASSWORD

Set if some of the menus shall be password protected or not. The menus that will be protected by this password are:
• PRICE PROGRAMMING
• PROGRAM PARAMETERS
• LANGUAGE SETTINGS
• USER INTERFACE
• YOUR PASSWORD

• CONFIG. 1

• I/O CONFIGURATION

Set the desired password.
The password can be changed at any time.
0000 = No password
For some markets / segments a default password is set from factory: 9191.
4.6 I/O CONFIGURATION
Activate the I/O CONFIGURATION menu.
If a password is set in YOUR PASSWORD, a password is needed to continue. Enter the password set in YOUR PASS-
WORD and press the control knob.
The display will now show the following submenus:

• LIST ALL I/O BOARDS

• SETUP ALL I/O BOARDS

• ADD/REMOVE I/O BOARD

4.6.1 LIST ALL I/O BOARDS
All the I/O boards in the machine are listed on the display.
1 = Active I/O board
0 = Inactive I/O board
4.6.2 SETUP ALL I/O BOARDS
After replacing an I/O board or in instances where an I/O board has been added to the machine, the new I/O board
must be set up in order to activate the function options.
The function options of the I/O board are controlled by the parameter software loaded on the relevant program
device.
Set up the I/O boards one by one by pressing the service button on the board. Follow the instructions on the display.
4.6.3 ADD/REMOVE I/O BOARD
A new I/O board that has been set up needs to be added in this menu in order to function. (If the machine software is
prepared for an extra I/O board).
Select the I/O board you want to add or remove and press the control knob. Add or remove up the I/O board by press-
ing the service button on the board. Follow the instructions on the display.
Note!
I/O boards that the machine must have to operate can not be removed.
4.7 CONFIG. 1
Activate the CONFIG. 1 menu.
If a password is set in YOUR PASSWORD, a password is needed to continue. Enter the password set in YOUR PASS-
WORD and press the control knob.
Activate the relevant sub-menu.
The sub-menus are divided into different sections, COMMON and DRYER.
In COMMON all parameters valid for both washer extractors and tumble dryers are listed.
In DRYER all parameters valid only for tumble dryers are listed.
Programming and Configuration Manual
17