Error Code; Restore Settings - Electrolux Compass Pro Programming And Configuration Manual

Programming and Configuration Manual
30

4.9 ERROR CODE

Activate the ERROR CODE menu.
The listed error codes can be triggered without "a real error has occurred". This menu makes it possible to deactivate
such an error code.
Select the error code to activate or deactivate.
Note!
Do not deactivate an error code before the cause for it is verified and resolved.
YES = Activated
NO = Deactivated

4.10 RESTORE SETTINGS

Activate the RESTORE SETTINGS menu.
If a password is set in YOUR PASSWORD, a password is needed to continue. Enter the password set in YOUR PASS-
WORD and press the control knob.
The display will now show this menu:
• LANGUAGE
• PROGRAM PARAMETERS
• ACTIVATED PROGRAMS
• CONFIG (1&2)
• RESTORE BUTTON CONFIG
• RESTORE CBT
• RESET TO FACTORY
• TOTAL RESTORE
LANGUAGE
If this menu is activated and saved the set language will be reset to the default language set from factory.
If there was no default language set from factory; when exit the service menu you will be forced to set a language
again.
PROGRAM PARAMETERS
If this menu is activated and saved the changes made in program parameters will be reset to the default settings from
factory.
ACTIVATED PROGRAMS
If this menu is activated and saved any changes to the activated programs list will be reset to the default settings from
factory.
CONFIG (1&2)
If this menu is activated and saved all settings in Config. 1 and 2 will be reset to the default settings from factory.
RESTORE BUTTON CONFIG
If this menu is activated and saved the settings for the config. button will be reset to the default settings from factory.
If there was no default settings for the config. button set from factory; when exit the service menu you will be forced
to set up the config button again.
RESTORE CBT
A password is needed to continue. The display will now show an eight figure code. Call authorized service and state
the code. Authorized service will assign a pass code. Enter the pass code you have been given and press the control
knob.
This will reset communication to factory default and the error code NO CBT COMMUNICATION will be reset.