Interface Ping Test Between Interfaces 'If1' And 'If2; Start 30 Min Burn-In, Testing Ram, Storage Media And Crypto Accelerator - D-Link DFL-260E Reference Manual

selftest -ping
Example 2.14. Interface ping test between interfaces 'if1' and 'if2'
selftest -ping -interfaces=if1,if2
Example 2.15. Start 30 min burn-in, testing RAM, storage media and crypto accelerator
selftest -burnin -minutes 30 -media -memory -cryptoaccel
Usage
selftest -memory [-num=<Integer>]
Check the sanity of the RAM.
selftest -media [-size=<Integer>]
Check the sanity of the disk drive.
selftest -mac
Check if there are MAC address collisions on the interfaces.
selftest -ping [-interfaces=<Interface>]
Run a ping test over the interfaces.
selftest -throughput [-interfaces=<Interface>]
Run a throughput test over the interfaces.
selftest -traffic [-interfaces=<Interface>]
Run a traffic test over the interfaces.
selftest -cryptoaccel
Verify the correct functioning of the accelerator cards.
selftest -burnin [-hours[=<Integer>]] [-minutes[=<Integer>]]
[-memory] [-media] [-ping] [-throughput] [-traffic]
[-cryptoaccel] [-size=<Integer>]
Run burn-in tests for a set of sub tests. If no sub tests are specified the following are included:
-memory, -ping, -traffic, -cryptoaccel.
selftest -abort
Abort a running self test.
Chapter 2: Command Reference
80