Ipsectunnel - D-Link DFL-260E Reference Manual

3.66. IPsecTunnel

Description
An IPsec tunnel item is used to define IPsec endpoint and will appear as a logical interface in the
system.
Properties
Index
Name
LocalNetwork
RemoteNetwork
RemoteEndpoint
IKEConfigModePool
IKEAlgorithms
IPsecAlgorithms
IKELifeTimeSeconds
IPsecLifeTimeSeconds
IPsecLifeTimeKilobytes
EncapsulationMode
AuthMethod
PSK
LocalID
RemoteID
Chapter 3: Configuration Reference
The index of the object, starting at 1. (Identifier)
Specifies a symbolic name for the interface.
(Identifier)
The network on "this side" of the IPsec tunnel. The
IPsec tunnel will be established between this
network and the remote network.
The network connected to the remote gateway.
The IPsec tunnel will be established between the
local network and this network.
Specifies the IP address of the remote endpoint.
This is the address the firewall will establish the
IPsec tunnel to. It also dictates from where
inbound IPsec tunnels are allowed. (Optional)
Selects IKE Config Mode Pool to use for the tunnel.
(Optional)
Specifies the IKE Proposal list used with the tunnel.
(Default: High)
Specifies the IPsec Proposal list used with the
tunnel. (Default: High)
The lifetime of the IKE connection in seconds.
Whenever it expires, a new phase-1 exchange will
be performed. (Default: 28800)
The lifetime of the IPsec connection in seconds.
Whenever it's exceeded, a re-key will be initiated,
providing new IPsec encryption and authentication
session keys. (Default: 3600)
The lifetime of the IPsec connection in kilobytes.
(Default: 0)
Specifies if the IPsec tunnel should use Tunnel or
Transport mode. (Default: Tunnel)
Certificate or Pre-shared key. (Default: PSK)
Selects the Pre-shared key to use with this IPsec
Tunnel.
Specifies the local identity of the tunnel. (Optional)
Identities authorized to setup a tunnel. If not set, all
219