D-Link DFL-260E Reference Manual page 239

PrivateIP
PrivateIP6
NOCHB
MTU
Metric
DHCPEnabled
DHCPHostName
AutoSwitchRoute
DHCPPassthrough
NonIPPassthrough
BroadcastFwd
AutoInterfaceNetworkRoute
AutoDefaultGatewayRoute
DHCPDNS1
DHCPDNS2
DHCPv6DNS1
DHCPv6DNS2
EnableRouterAdvertisement
SNMPIndex
MemberOfRoutingTable
RoutingTable
Chapter 3: Configuration Reference
The private IP address of this high availability node.
(Optional)
The private IP6 address of this high availability
node. (Default: localhost6)
This will disable sending Cluster Heartbeats from
this interface (used by HA to detect if a node is
online and working). (Optional)
Specifies the size (in bytes) of the largest packet
that can be passed onward. Must be 1294 or larger
when IPv6 is enabled. (Default: 1500)
Specifies the metric for the auto-created route.
(Default: 100)
Enable DHCP client on this interface. (Default: No)
Optional DHCP Host Name. Leave blank to use
default name. (Optional)
Allows traffic to be forwarded transparently across
all interfaces with Transparent Mode enabled that
belong to the same routing table. (Default: No)
Allow DHCP to pass through transparently.
(Default: No)
Allow non-IP protocols
transparently. (Default: No)
By default, this traffic is dropped. (Default: No)
Automatically add a route for this interface using
the given network. (Default: Yes)
Automatically add a default route for this interface
using the given default gateway. (Default: Yes)
IP of the primary DNS server. (Optional)
IP of the secondary DNS server. (Optional)
IP of the primary IPv6 DNS server. (Optional)
IP of the secondary IPv6 DNS server. (Optional)
Enable Router Advertisement for this interface.
(Default: No)
Interface index assigned by the system when
persistent interface indexes are enabled. (Default:
0)
All or Specific. (Default: All)
Specifies the PBR table to insert the interface IP
route into. It also means that the specified routing
table will be used for all routing lookups, unless
overridden by a PBR rule. (Default: main)
239
to pass through