D-Link DFL-260E Reference Manual page 223

IPsecDisablePKAccel
IPsecEnableFramedIP
IPsecEnableRadiusAccountRequestStart
IPsecXCBCFallbackToRFC3664
IPsecDeleteSAOnIPValidationFailure
IPsecSAKeepTime
IKEDisableDPD
IPsecForceRequireCookie
IPsecDisableCallingStationID
IpsecUseClientCfgModeAttributes
IPsecAllowIKEPortChange
IPsecLogKeyMaterial
IPsecESPDetectNATChange
Note
This object type does not have an identifier and is identified by the name of the type
only. There can only be one instance of this type.
Chapter 3: Configuration Reference
Disable hardware acceleration for public-key
operations. (Default: No)
Include Framed IP address in the RADIUS Access
Request message. (Default: No)
Enable sending of Accounting Request Start
message, including Framed IP address. (Default:
No)
Enable fallback to XCBC RFC3664 if XCBC RFC4344
fails when using IKEv2. (Default: Yes)
Enable tunnel deletion when decrypted source IP
address doesn't match the remote net. (Default:
No)
Number of seconds a SA will linger after a delete.
(Default: 3)
Disable Dead Peer Detection in IKEv2. (Default: No)
Force requirement of cookies. Used for test
purposes only! (Default: No)
Disable calling station ID and called station ID in
RADIUS messages. (Default: No)
Use client requested subnet attributes for config
mode. (Default: No)
Allow port change to 4500 in IKE negotiation even
when no NAT is detected. (Default: No)
Enable logging of IPsec key material. (Default: No)
Use inbound ESP packets to detect that NAT
mappings have changed. (Default: Yes)
223