Fixture Settings; Fixure Information - ProLights ECLIPSETU User Manual

16

3.13 FIXTURE SETTINGS

It is possible to change the parameter value in the following way:
Dimmer
• Enter in Dimmer mode to select specific dimming curve, press the button MENU so many times
until shows DIM MODE, and press the button ENTER to confirm.
• Press the button UP/DOWN to select OFF - DIM1 - DIM2 - DIM3.
• Press ENTER button to store.
• Press the MENU button to go back or to meet the waiting time to exit the setup menu.
Back Light
• To activate Backlight display press the button MENU so many times until shows BACK LIGHT, and press
the button ENTER to confirm.
• Press the button UP/DOWN to select ON - 10S - 20S - 30S.
• Press ENTER button to confirm the selection.
• Press the MENU button to go back or to meet the waiting time to exit from the setup menu auto-
matically.
Fan Mode
• To set the Fan Mode press the button MENU so many times until shows FAN MODE, and press the
button ENTER to confirm.
• Press the button UP/DOWN to select AUTO - HIGH.
• Press ENTER button to confirm the selection.
• Press the MENU button to go back or to meet the waiting time to exit from the setup menu auto-
matically.
LED Frequency
• To adjust the frequency of the LEDs, press the MENU button repeatedly until the display shows LED
Frequency, and then press the ENTER button.
• Select the frequency (600Hz - 1200Hz - 2000Hz - 4000Hz - 25kHz) using the UP/DOWN buttons.
• To confirm, press the ENTER key.
• Press the MENU button to go back or wait a few seconds to exit the setup menu.
3.14 FIXTURE INFORMATION
Auto Test
Allow checking the proper functioning of the unit. Start the automatic test in the following way:
• Press the button MENU so many times until shows INFORMATION, then press the ENTER button to
confirm.
• Using the button UP/DOWN to select AUTO TEST.
• To confirm and start the automatic test press the ENTER button.
Fixture Hours
Show the fixture working hours.
• Press the button MENU so many times until shows INFORMATION. Press the button ENTER to confirm
• Using the button UP/DOWN to select FIX HOURS, then press the button ENTER to confirm
• Then the display will show the working hours.
ECLIPSE