HP Synergy 480 Gen9 Maintenance And Service Manual page 52

6. Close the processor retaining bracket. When the processor is installed properly inside the processor
retaining bracket, the processor retaining bracket clears the flange on the front of the socket.
CAUTION:
Do not press down on the processor. Pressing down on the processor might damage the processor
socket and the system board. Press only in the area indicated on the processor retaining bracket.
CAUTION:
Close and hold down the processor cover socket while closing the processor locking levers. The
levers should close without resistance. Forcing the levers closed can damage the processor and
socket, requiring system board replacement.
7. Press and hold the processor retaining bracket in place, and then close each processor locking lever.
Press only in the area indicated on the processor retaining bracket.
52 Removal and replacement procedures