Removing And Replacing An Access Panel; Removing And Replacing A Drive Blank - HP Synergy 480 Gen9 Maintenance And Service Manual

5. Review the compute module front panel LEDs to determine the compute module status. For more
information on the compute module LEDs, see "Component identification."

Removing and replacing an access panel

To remove the component:
Procedure
1. Power down the compute module.
2. Remove the compute module.
3. Press the access panel release button.
4. Slide the access panel towards the rear of the compute module, and then lift to remove the panel.
To replace the component:
1. Place the access panel on top of the compute module.
2. Slide the access panel forward until it clicks into place.

Removing and replacing a drive blank

Remove the component as indicated.
32 Removing and replacing an access panel
1
2