HP Synergy 480 Gen9 Maintenance And Service Manual page 43

CAUTION:
To avoid damage to the processor, do not touch the bottom of the processor, especially the contact
area.
To replace the component:
CAUTION:
To avoid damage to the system board, processor socket, and screws, do not overtighten the heatsink
screws.
1. Install the processor. Verify that the processor is fully seated in the processor retaining bracket by visually
inspecting the processor installation guides on either side of the processor. THE PINS ON THE SYSTEM
BOARD ARE VERY FRAGILE AND EASILY DAMAGED.
Removal and replacement procedures 43