Installing The Compute Module - HP Synergy 480 Gen9 Maintenance And Service Manual

Procedure
1. Identify the proper compute module.
2. Power down the compute module.
3. Remove the compute module.
4. Install the compute module end cap when the compute module is outside of the frame.
5. Place the compute module on a flat, level work surface.
To replace the component, reverse the removal procedure.
WARNING:
To reduce the risk of personal injury from hot surfaces, allow the drives and the internal system
components to cool before touching them.
CAUTION:
To prevent damage to electrical components, properly ground the compute module before beginning
any installation procedure. Improper grounding can cause ESD.

Installing the compute module

Procedure
1. Verify that the device bay is configured for a half-height compute module. For more information, see the
setup and installation guide for the frame on the Hewlett Packard Enterprise website.
2. Remove the compute module end cap.
30 Installing the compute module