Removing And Replacing A Drive; Removing And Replacing An Sff Flash Adapter - HP Synergy 480 Gen9 Maintenance And Service Manual

CAUTION:
To prevent improper cooling and thermal damage, do not operate the compute module unless all bays
are populated with either a component or a blank.
To replace the blank, slide the blank into the bay until it locks into place.

Removing and replacing a drive

To remove the component:
Procedure
1. Determine the status of the drive from the drive LED definitions.
2. Back up all data on the drive.
3. Remove the drive.
To replace the drive, slide the drive into the bay until it is fully seated, and then close the latch handle to lock
the drive in the bay.

Removing and replacing an SFF flash adapter

To remove the component:
CAUTION:
Removing the SFF Flash Adapter will remove two uFF drives and might cause one or more logical
drives to fail.
Procedure
1. Power down the compute module.
2. Slide the adapter ejection handle release latch up. The handle will eject from the adapter.
3. Pull the adapter handle to remove the SFF flash adapter.
Removing and replacing a drive 33