Fronius Selectiva 2100 Service Manual page 123

(3)
Installing the axial fan:
(3)
(2) (2) (2)
Remove the bushing sleeve (1) from
6
(1)
the axial fan cable
Undo the two 5x8 TX25 screws (3)
7
Remove the axial fan
8
(3)
Place the axial fan in position as
1
(1)
shown, with the direction of air flow into
the device
Fit the axial fan to the fan mounting
2
with two 5x8 TX25 screws (3)
[2.1 Nm]
Attach the bushing sleeve (1) to the
3
axial fan cable
(3)
CAUTION! Be careful not to press
on the rotor when inserting the fan
(1)
Insert the fan module into the device
4
Fit the fan module with three 5x12
5
TX25 screws (2)
[3 Nm]
Place the fitted axial fan cable bushing
6
sleeve into the recess provided (1)
Fit the axial fan cable on the primary
7
power module and place it in the strain-
relief device
Fit the front panel and the device frame
8
on the AC side (see the "Closing the
device" section)
123