Table of Contents
Advertisement
Master-Slave Operation: This function will allow you to link up to 16 units together and operate without a
controller. In a Master-Slave set-up one unit will act as the controlling unit and the others will react to the
controlling units programs. Any unit can act as a Master or as a Slave.
1. Using standard XLR microphone cables, daisy chain your units together via the XLR connector on the rear of
the units. Remember the Male XLR connector is the input and the Female XLR connector is the output. The first
unit in the chain (master) will use the female XLR connector only - The last unit in the chain will use the male
XLR connector only. For longer cable runs we suggest a terminator at the last fixture.
2. Set the Master to your desired operating mode.
3. Set the Slave unit(s) to address "001".
4. The slave unit(s) will now follow the Master unit.
UC IR/AIRSTREAM APP CONTROL
The UC IR (sold separately) infrared remote gives you control of various functions (See below). To control the
fixture you must aim the remote at the front of the fixture and be no more than 30 feet away.
The Mini Dekker LZR is also compatible with the Airstream IR app. The IR transmitter is available through any
ADJ dealer or through the ADJ parts website. Plug the transmitter into the headphone jack of your iOS phone
or tablet. To control your IR fixture you must raise the volume to the maximum on your iOS phone or tablet and
aim the transmitter at the front of the fixture and be no more than 15 feet away. After you have purchased the
Airstream IR transmitters, the app is a free download from the app store for your iOS phone or tablet. The app
comes with 3 pages of control depending on the IR fixture you are using. Please see below for IR functions
including the corresponding app page.
Works with App page 1.
STAND BY - Pressing this button will blackout the fixture. Press the button again to return to the initial state.
FULL ON - Hold this button down to fully light up the unit. When you let the button go, the unit will return to its
previous state.
STROBE - Press and hold this button for strobing.
FADE/GOBO - This button is invalid for this fixture.
"DIMMER +" and "DIMMER -" - These buttons are invalid for this fixture.
COLOR - Press this button to select a color. Use buttons 1-9 to find your desired color.
1-9 - Use buttons 1-9 to select your desired color when color mode is active. Use buttons 0-2 to select your
desired show when in show mode.
SOUND ON & OFF - Use the buttons to activate and deactivate sound active mode.
SHOW 0 - Press this button to activate show mode and press this button again to activate random show (Show
0). Use buttons 1 & 2 to to run either show 1 or show 2.
2 CHANNEL DMX MODE
Channel
1
2
CAD DRAWING
A.D.J. Supply Europe B.V. – www.americandj.eu – Mini Dekker LZR Instruction Manual Page 12
Value
0 - 9
10 - 89
90 - 169
170 - 255
0 - 247
248 - 255
Function
SHOW MODE
NO FUNCTION
SHOW 0 (LED, LASER, & STROBE)
SHOW 1 (LED)
SHOW 2 (LASER)
SHOW SPEED/SOUND SENSITIVITY
SHOW SPEED SLOW - FAST
SOUND ACTIVE
Hide quick links:
Advertisement
Table of Contents
