•
55:55 appears on the display and the drain pump turns on.
•
44:44 appears in the display and the inner drum then spins up to maximum.
•
When END is displayed, press the WASH TEMP button to check all the LEDs.
•
To end the tests, press the POWER button.
11.2
Water Valve Tests
Hot Valve
Select the EVERYDAY
deactivate the hot valve, press the WASH TEMP button again.
Cold Valve 1
Select the EVERYDAY
cold valve, press the SPIN button again.
Cold Valve 2
Select the EVERYDAY
deactivate the cold valve, press the OPTIONS button again.
11.3
Drum Rotation Test
Rotate Drum Clockwise
Select the COTTON
WASH TEMP button again.
Rotate Drum Counter Clockwise
Select the COTTON
button again.
11.4
Door Lock Test
Select the HEAVY
displayed for 2 seconds to indicate the lock action and the door should be locked.
To deactivate, press the WASH TEMP button again. OPEN will be displayed for 2 seconds to indicate the
unlocking action and the door should be able to be opened.
11.5
Heater Test
NB. The drum must contain water that is visible in the drum before the heater is activated.
Place a clamp-on Amp meter around either of the wires going to the element. Select the HEAVY
then press the SPIN button to activate the heater. The current drawn should be approximately 9 amps. To
deactivate, press the SPIN button again.
cycle, then press the WASH TEMP button to activate the hot valve. To
cycle, then press the SPIN button to activate the cold valve 1. To deactivate the
cycle, then press the OPTIONS button to activate the cold valve 2.
cycle then press the WASH TEMP button to activate. To deactivate, press the
cycle, then press the SPIN button to activate. To deactivate, press the SPIN
cycle, then press the WASH TEMP button to activate the lock. LOCI - will be
31
479646
To
cycle,