Table of Contents
Advertisement
13.1.2
No Tap
Error message: The required water level has not been reached within 8 minutes
Trouble Shooting:
Check for water leaks from the
bottom of the washer, inlet hoses
and drain hose.
Check that the taps are on and the
water pressure is between 0.2 and
1 MPa.
Y
Check the inlet valves filters are
not blocked.
Turn power on and select the pre-wash
cycle, then start machine. Open the
dispenser drawer and check that the
water is entering.
N
Check the voltage across the
water valves measure 220-240V
AC.
Check that there is 220-240v AC
being supplied from the PCB
assembly at CN3-4, CN3-5, CN3-
6 and CN1-2.
Replace display module.
Repair any leaks found.
Turn taps on or advise customer to have
water pressure increased.
N
Clean the filters
Check that the pressure sensor tube is
not leaking air and the drain hose height
is between 0.8 and 1.2m.
Check
assemblies. Should read 3.6KΩ +/- 10%.
Check that the harness is not open
circuit.
35
resistance
of
the
valve
479646
Advertisement
Table of Contents
