Table of Contents
Advertisement
13.1.14 Err 37
Error Message: Draining error, water has not emptied within 6 minutes
Check machine is empty of water.
Check if drain pump is energised
by entering diagnostics, selecting
delicate cycle and toggling the
wash temp button.
While in pump diagnostics, use
the wash temp button to turn the
pump on. Check that there is 220-
240v across the pump terminals.
N
While in pump diagnostics, use
the wash temp button to turn the
pump on. Check that there is 220-
240v AC at the PCB connector
CN1-2 and CN1-5.
Replace the display module.
Turn off the power and disconnect the wires from pressure sensor.
Measure the resistance between the pins. It should read between 10 &
15 Ω. If not, the pressure sensor has failed and needs replacing. If
correct, refit wires and continue with trouble shooting.
Y
47
Check that the drain hose is not kinked or the
drain hose is not jammed. Tilt machine back,
open the filter and clean it.
Replace the drain
pump.
Y
479646
Check
the
harness
connecting the pump to
the PCB for continuity.
Advertisement
Table of Contents
