Err 10 - Fisher & Paykel WH8560J1 Service Manual

13.1.12 Err 10

Error Message: Temperature sensor (NTC) failure. (Displayed at end of a
program)
Turn the power off and check that
the resistance of the temperature
sensor is approximately 13K ohms
at 25  C.
Y
Check that NTC is connected
properly.
Check the two Black harness wires
on CN14 of the NTC connector are
connected at the PCB.
Check the resistance of the NTC
between CN14-3 & CN14-4, the
black wires at the PCB end. Are
they open circuit?
Replace the display module.
Replace the NTC.
Ensure the NTC is correctly
connected.
Repair the connections.
Look for open circuit wire in
NTC harness.
45
479646