Removing The Treadmill Hood - Precor TRM 885.v2 Service Manual

Replacement Procedures
This section contains the following replacement procedures:

Removing the Hood

Removing the Deck Trim Strips

Removing the Front Side Trim

Replacing the Line Cord, Circuit Breaker or ASL

Replacing the Line Filter

Replacing Drive Motor

Replacing the Lift motor

Replacing the Incline Platform

Replacing the Motor Control Module

Replacing the End Cap or Belt Guard

Drive Belt and Roller Replacement

Take Up Roller Replacement

Running Belt and/or Deck Replacement

Removing the treadmill hood.

Most replacement procedures will require that the hood over the front drive system is removed.
There are six #3 Phillips screws that secure the hood to the frame. The front of the hood is curved
to provide a sleek appearance to the treadmill. It will be necessary to flex the cover to make this
curved material clear the frame. Similarly, it is necessary to flex the cover outward to replace the
cover onto the tread when the service is accomplished.
Procedure:
1. Remove the screws securing the hood to the frame.
2. Grasping the front bottom of the hood, pull out and lift up to clear the curved edge of the frame.
See figure 8-1.
3. Reverse the process to install the cover and secure it with the screws removed in step 1.
Figure 18, Front cover removal, 1 – Grasp and pull, 2- Lift up and away
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 72