Precor TRM 885.v2 Service Manual page 96

Weekly Task
Vacuum and clean area underneath
equipment .
1
Clean surfaces on foot contact locations
Connect power cord and switch the input power ON, set incline to 0%.
Verify the treadmill operation and
functionality.
Note: 1). Perform test with incline set to maximum level and power OFF and power cord
disconnected.
Monthly
Perform the following maintenance tasks every month.
Monthly Task
Verify the Safety clip is attached to the
lanyard and functional.
Inspect the power cord for damage and
that the cord clamp is securely installed
Visually inspect the running belt and deck
condition.
Verify the running belt alignment and
tracking.
Clean the treadmill's frame using a cloth
dampened with an approved cleaning
1
solution .
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Vacuum and/or use damp mop to clean floor area
underneath equipment. Make sure the floor is
completely dry.
. Use a soft nylon scrub brush to clean the grooves and
1
textured surfaces on foot contact locations.
Perform the "Operation Verification" procedure to
verify unit features and functions (parameter controls,
HHR, Stop key. etc.).
Pull on the lanyard attached to the Safety clip which
trips the Restart (Stop/Restart) switch. The "PUSH
TO RESET SWITCH" message is shown and an
arrow pointing to the Restart switch. Treadmill slows
and stops.
Inspect the power cord, make sure it is not damaged
. or underneath the treadmill. Verify the cord clamp is
1
securely installed.
Make sure the deck and belt are not worn and are in
good condition, replace as necessary.
Verify the running belt alignment and tracking, see
"Running Belt Tension and Tracking Adjustment"
procedure.
Use only approved plastic cleaners.
Instruction
Instruction
Page 96