Error Codes - Precor TRM 885.v2 Service Manual

Figure 13: Standard Error Codes Flow Chart

Error Codes

The subsequent pages list the details of each of the error codes that exist within the Precor
software hierarchy for the TRM 800-V.2. Each page will include a description of the error code
being displayed and the systems associated with the error code.
Potential causes for the error codes will be listed with the most likely cause first and the least
likely because listed last. It must be understood that this manual can not anticipate every
possible cause for a particular error code. However, it should list the causes encountered in the
majority of cases.
The manual will then list the suggested remedies associated with each of the possible causes.
The possible remedy listing will numerically coincide with the possible cause listing.
- When faults are detected, and error codes generated, certain rules will be followed in the
software.error is recorded in the console if the new value is different than the old value
(Odometer/Hour-meter/etc). For example, two faults caused inside a minute with no belt
movement records one error.
- For all errors that result in the Motor Controller stopping or slowing the belt, when the
workout is resumed the speed will resume at 1MPH.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
Type
Page 40