Precor TRM 885.v2 Service Manual page 97

Monthly Task
Clean outer surface of running belt
Clean drive motor and pulleys
Vacuum debris from around motor,
pulleys, and floor underneath the
1
treadmill .
Inspect visible welds, frame, and wire
1
connections .
Check for loose fasteners
Clean and lubricate the Lift Motor jack
screw.
Perform functional test to verify all features
are performing properly
Note: 1). Perform task with power removed and incline set to maximum level.
2) Diagnostic tests will vary depending on console model.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
1
. Use water and a soft nylon scrub brush to clean the
outer surface of the running belt. Do not use chemical
cleaners.
1
. Remove hood and use wire brush to clean belt and
pulley grooves.
Remove hood. Use a vacuum cleaner (recommended
with static protection feature) to clean debris and lint
from front area under the front cover. Be careful not to
bring the nozzle to close to any electronic circuit
boards.
Do a visual check of welds and frame. Check for
loose wire connections.
1
. Check all fasteners and clips for proper tightness and
torque.
Raise the Incline to maximum, Switch the input power
OFF, and disconnect the power cord. Clean the jack
screw and apply approved grease.
Verify the unit available functions and programs. Do
the "Operation Verification procedure".
2
.
Instruction
Page 97