Service Access Codes; Accessing The Service Software; P80 Console - Precor TRM 885.v2 Service Manual

Service Access Codes

Included topics:

Service Access Codes

Club Parameter - Settings (5651565)

Information Display (65)
Service Access Codes
The service access codes are utilized on the following consoles:

P10

P30

P80
The service codes access three functional modes, Hardware Validation, Club Parameters, and an
Information Display.

Hardware Validation is a set of functional diagnostic tests that are useful in troubleshooting
problems as well as verifying proper operation.

Club Parameters are sometimes referred to as Club Settings or Workout Parameters and
are used to manage usage of the machine.

Information Display is used to access information such as the odometer, software versions
and error logs.

Accessing the Service Software

Accessing the service code functional modes is accomplished in the same way on the P10 and P30
consoles. The differences in the P80 will be discussed below.
To enter Service Software, press either the STOP or the PAUSE or RESET key followed by a
numeric code for the area of service software you wish to access.
The standard access codes use sequential key presses, not simultaneously holding down multiple
keys. The allowable delay between key presses is short. If too much time is taken between key
presses or the wrong key is pressed, the access procedure will be aborted. If the access is aborted,
it will be necessary to start over from the beginning.

P80 Console

 Use the System Settings to test your equipment and set parameters that benefit your users and
your facility.
The Welcome screen will be the first screen you see when you approach the P80 console. Press
the Pause key and continue holding it down while you single press in sequential order an X
configuration on the Volume and Channel key pad (Channel Up, Volume Down, Volume
Up, Channel Down). Release the Pause key when done pressing the arrows.
NOTE
The keypad X configuration sequence should be not faster than 1 second between
each key stroke. Any speed faster than 1 second may result in an unsuccessful access
to the sign-in screen.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 14