Replacing The Take-Up Roller - Precor TRM 885.v2 Service Manual

4. Remove the hitch pin and clevis pin that fastens the lift motor tube to the incline platform. While
the incline tube is not fastened to the incline platform, care must be taken to not allow the
incline tube to rotate. If the incline tube rotates, the lift motor must be calibrated per Procedure,
Calibrating the Lift motor.
5. Remove the two large hitch pins (one each side) from the incline platform to frame mounting.
See Figure Below. Remove the incline platform mounting pins and remove the incline platform
from the treadmill.
6. Remove the wheels from the old incline platform and remount them on the replacement incline
platform.
7. Set the replacement incline platform into position and slide the incline mounting pins into place.
Fasten the incline mounting pins with the hitch pins removed in step 4.
8. If the incline tube or the lift motor's drive screw has been moved, calibrate the lift motor per
Procedure, Calibrating the Lift motor, at this time.
9. Fasten the incline tube to the incline platform with the clevis pin and hitch pin removed in step 3.
10. Set the treadmill in its upright position, replace all covers and thoroughly check it per
Treadmill Operation

Replacing the Take-Up Roller

1. Set the treadmill circuit breaker in the off position and unplug the treadmill's line cord from the
AC outlet.
2. Remove the hood and both Deck Trim Platforms.
© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law
(see "Operation Verification".
Checking
Page 83