Mvp-5100/Mvp-5150 Battery Removal And Installation; Removing The Old Battery From The Mvp-5100 Or Mvp-5150 - AMX MVP-5200i Installation Manual

MVP-5100/MVP-5150 Battery Removal and Installation

After the latest firmware has been installed and the battery fully discharged, the battery may now be removed
from within the device. A Phillips-head screwdriver is necessary to complete the removal and the new battery
installation.

Removing the Old Battery From the MVP-5100 or MVP-5150

Do NOT discharge the battery before installing the latest MVP-5100/5150 firmware
(v2.66.21 or later), available at www.amx.com. Prior to battery removal, run the
device until the battery is completely discharged.
1.
Before starting, remove the battery and back cover from their packaging, and inspect the assembly for any
damage or distortion.
If the battery and back cover shows evidence of damage, contact AMX for
replacement and proper disposal information.
2.
Place the device face-down on a surface that will not scratch the unit and remove the five screws from the
back cover (FIG. 5).
FIG. 5 Screw placement at the back cover of the MVP-5100
3.
Discharge all static electricity that may have built up on your body, either by using a static discharge strap
or by touching a nearby piece of metal.
Battery Replacement & Firmware Upgrade - 5.2" Modero ViewPoint Touch Panels
Two of the screws are at the upper corners of the device, underneath rubber feet that also act as
screw covers. Remove the rubber feet to access the screws.
Remove the lower rubber foot to reach the remaining three screws.
IR emitter panel
Battery Removal and Replacement
Upper screws
(underneath rubber feet)
Serial number
label
Lower screws
(underneath rubber foot)
21