Reconnecting The Battery To The Mvp-5200I - AMX MVP-5200i Installation Manual

3.
Carefully remove the back cover of the device and detach the battery lead at the female battery connector
(FIG. 2). This will allow the back cover to be detached from the device.
FIG. 2 Interior of MVP-5200i, including female battery connector
Attach the residual voltage discharge adaptor (SAA5966-27-A) to the old battery and
allow any remaining charge to dissipate. Note that the adaptor may become warm to
the touch for up to 12 hours.
Do not place the old battery in the plastic bag (for return shipment), until it has cooled.

Reconnecting the Battery to the MVP-5200i

1.
On the back cover, make sure that the battery connector wiring runs to the right.
Excess battery
Resistor location
FIG. 3 Path of excess battery wiring
2.
Make sure to seat fully the battery plug to the connector in the device (FIG. 2). If fingers cannot be used,
use a clean, nonconductive stick or probe to seat the connectors.
Battery Replacement & Firmware Upgrade - 5.2" Modero ViewPoint Touch Panels
Battery Connector
Make sure that the excess battery wiring fits in the space to the bottom left of the battery placement
(FIG. 3).
wiring path
MVP-BP-5X battery placement
Battery Removal and Replacement
19