Table of Contents
Advertisement
6.2.3. Connect 155M SDH interfaces
● Connect the fiber to the SDH interfaces on front panel.
● If proper connected the LOS indicator light will turn off.
Please refer to 6.3
6.2.4. Connect E1 electrical port
Connect E1 electrical port (2MM) through E1 cable with other device. Each E1
cable has 8 E1 IN or OUT pins in one end and the other end has 8 BNC
connectors, each connector has a number stands for the first channel to the
eighth channel.
6.2.5. Connect Ethernet port(If there is Ethernet service)
Connect the Ethernet port through Ethernet cable with router or Ethernet
switch and the LNK/ACT will ON if the connection is correct.
6.2.6. Connect SNMP network management port
Connect the SNMP network management port through Ethernet cable with
related device and the LNK/ACT will ON if the connection is correct.
6.2.7. Connect CONSOLE port
●
Connect the RJ45 connector of CONSOLE cable with CONSOLE interface
on the front panel.
●
Connect the DB9 connector PC serial interface.
●
Start Hyper Terminal on PC:
Raisecom Technology Co., Ltd
18
Advertisement
Table of Contents
