Table of Contents
Advertisement
6.1.
Cautions
Check whether the type of device, spare parts and number are same with that
of packing list. Make sure the device appearance is in excellent condition.
There must be drying process if the device has been damp.
To make sure normal working of the device, please follow the following steps:
●
Read this manual carefully
●
Fix and install the device
●
Prepare the fiber and E1 cable
●
Connect the fiber or other cables
● If this is your first use of the device, please refer to configuration manual
and command manual.
● Use the device properly
6.2.
Installation
6.2.1. Cable preparation
The cables you need to prepare are:
Table 6-1 OPCOM3100-155 cable specifications
Interface
10/100Mbps Ethernet
electrical
interface/SNMP
interface
CONSOLE cable
Optical fiber
E1cable
Power supply
interface
6.2.2. Install the extension slot
E1 and EOS sub card can insert into extension slot and cannot hot-swap.
6. Installation & Preparation
100Base-T category-5 UTP, the maximum distance is
100m.(users provide)
Refer to appendix.(Raisecom provides)
Multi mode fiber or single mode fiber with SC/SC or
SC/FC connector (customized)
Special 2mmE1 cable.
AC, 220V/10A power supply cable.
-48V DC, -48V/10A power supply cable.
+24VDC, +24V/10A power supply cable.
Raisecom Technology Co., Ltd
Specifications
17
Advertisement
Table of Contents
