Server Snmp Manager Command - HP 16-port SCS Installation Instructions Manual

Server SNMP
The Server SNMP command enables or disables SNMP UDP port 161 SNMP processing. When you disable SNMP
processing, you can still enable and disable traps with the Server SNMP Trap command. See "Managing the SCS
using SNMP."
Access right: SCON
Access level: APPLIANCEADMIN
Syntax:
server snmp enable|disable
Table 5-22 Server SNMP command parameter
Parameter
ENABLE|DISABLE
Server SNMP Community
The Server SNMP Community command defines read, write, and trap SNMP community strings. Community
names are case-sensitive.
The default community names are "public." If you enable SNMP, you are encouraged to change the community
values to prevent access to the MIB. See "Managing the SCS using SNMP."
Access right: SCON
Access level: APPLIANCEADMIN
Syntax:
server snmp community[readcomm=<name>] [writecomm=<name>] [trapcomm=<name>]
Table 5-23 Server SNMP Community command parameters
Parameter
READCOMM=<name>
WRITECOMM=<name>
TRAPCOMM=<name>

Server SNMP Manager command

The Server SNMP Manager command defines or deletes SNMP management entities. You can define up to four
management entities. If you delete all SNMP managers (or never add any), the SCS can be accessed using SNMP
from any IP address. See "Managing the SCS using SNMP."
Access right: SCON
Access level: APPLIANCEADMIN
Syntax:
server snmp manager add|delete <ip_address>
Table 5-24 Server SNMP Manager command parameters
Parameter
ADD|DELETE
<ip_address>
Description
Enables or disables SNMP processing
Default = Enable
Description
1 to 64 alphanumeric characters read community name.
Default = Public
1 to 64 alphanumeric characters write community name.
Default = Public
1 to 64 alphanumeric character trap community name. If you specify this parameter, the
name must be different from the read and write community names.
Default = Public
Description
Adds or deletes the specified SNMP management entity
IP address of SNMP management entity
SCS commands 65