Cli Mode; Entering Cli Mode; Exiting Cli Mode; Changing The Cli Access Character - HP 16-port SCS Installation Instructions Manual

Enabling session sharing
To enable automatic sharing, specify the Auto parameter.
-or-
To enable sharing only with the permission of the session originator, specify the Query parameter, which is the
default value.
Disabling session sharing
To disable session sharing, issue a Server Share command with the Disable parameter.
Initiating a device session with exclusive access
At the Username: prompt, enter your user name, followed by an E or e.
-or-
If device connections from the console port are enabled, enter a Connect command, followed by a port number or
name, then the Exclusive parameter.
A request for an exclusive connection is valid only when there are no other users currently using the port.
Displaying share mode information
Issue a Show Server command. The display indicates the share mode.

CLI mode

While you are connected to an attached serial device, you can enter CLI mode and enter SCS commands.

Entering CLI mode

To enter CLI mode, enter the CLI access character, by pressing the Ctrl+D keys. At the CLI prompt (>), you can enter
SCS commands.

Exiting CLI mode

Issue a Resume command.
resume
See "Resume command."

Changing the CLI access character

Issue a Server CLI or Port Set command, using the Char parameter to specify the CLI access character.
server cli char=^<char>
-or-
port set char=^<char>
If you issue a Port Set command with Char=None, then the CLI access character specified in the Server CLI
command will be used. You can use the Port Set command to override the Server CLI access character on a per-
port basis.
See "Server CLI command" and "Port set command."
Operations 30