Override Admin Account; User Logout Command - HP 16-port SCS Installation Instructions Manual

Table of Contents

Advertisement

> user add JaneDoe ssh=SCS_key2.pub ftp=10.0.0.3 access=pall
The following command adds the user name JDoe, with the password mysecret and the SCS Administrator access
level, which enables access to all ports, and SCS commands.
> user add JDoe pas=mysecret access=applianceadmin
The following command adds the user name JohnD with the password pword and the Administrator access level.
JohnD is assigned to the port groups Dev1 and Dev2.
user add JohnD password=pword access=adm group=Dev1,Dev2
User Delete command
The User Delete command removes a user name entry from the SCS user database. The user name may no longer
be used to authenticate a session with the SCS.
Access right: USER
Access level: ADMIN or APPLIANCEADMIN
Syntax:
user delete <username>
Table 5-40
User Delete command parameter
Parameter
<username>

Override Admin account

The Override Admin user account is setup by default and is located in the CONFIG database in stead of the USER
database. The user name is "Admin" and is case-sensitive. The account has no password. Upon fist login, the
authenticating user must assign an Override Admin password. If you are authenticating on the Serial Console and the
SCS has not been configured, the authenticating user will be asked to enter: IP address, Subnet Mask, Gateway, and
Override Admin password.
Access right: APPLIANCEADMIN
Access level: Admin
Syntax:
user override <username> pass<password>
Table 5-41
Override Admin account
Parameter
<username>
<password>

User Logout command

The User Logout command terminates a user's active sessions on the SCS. If the specified user has no active
sessions, an error message appears. For all active sessions that are terminated, a message is sent to the Telnet client,
and the Telnet connection is dropped.
Access right: USER
Access level: ADMIN (may log out all except APPLIANCEADMIN) or APPLIANCEADMIN
Syntax:
user logout <username>
Table 5-42
User Logout command parameter
Parameter
<username>
Description
User name to be deleted
Description
User name to be logged out
Description
User name
Password
SCS commands 75

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

48-port scs

Table of Contents