HP 16-port SCS Installation Instructions Manual page 69

Table 5-18 Server RADIUS command parameters
Parameter
PRIMARY | SECONDARY
IP=<radius_ip>
SECRET=<secret>
USER-RIGHTS=<attr>
AUTHPORT=<udp>
TIMEOUT=<time-out>
RETRIES = <retry>
DELETE
Examples
The following command specifies primary RADIUS server information. Default values will be used for the UDP port,
time-out, and retries values.
> ser radius primary ip=192.168.0.200 secret=ThePrimaryRadSecret user-rights=86
The following command deletes the primary RADIUS server definition.
> ser radius primary del
Server Reboot
The Server Reboot command reboots the SCS. During a reboot, any active Telnet sessions, including your own,
are terminated, and all users are informed accordingly. Any configuration changes that require a reboot will become
effective when the reboot completes.
When you enter this command, you are prompted to confirm or cancel the reboot.
You can also reboot the SCS by pressing the Reset button on the front panel. See "Rebooting."
Access right: SCON
Access level: APPLIANCEADMIN
Syntax:
server reboot
Server Security
The Server Security command specifies the authentication method, enables and disables access methods, and
enables and disables security lock-out. See "Using authentication method," "Enabling plain text Telnet and SSH
connection," and "Using security lock-out."
When you enter this command, you are prompted to confirm or cancel the specified information.
Access right: SCON
Access level: APPLIANCEADMIN
Syntax:
server security [authentication=<auth>] [encrypt=<conns>] [lockout=<hours>]
Table 5-19
Server Security command parameters
Parameter
Description
Indicates either the primary RADIUS server or the secondary RADIUS server is being defined or
deleted.
IP address of the RADIUS authentication server.
Eight to 24 character text string for shared secret with the RADIUS server. Enclose the string in
quotes if it contains spaces.
Attribute number defined on the RADIUS server, in the range 1–255.
UDP port for RADIUS authentication server, in the range 1–65535. This value is usually 1645
but can be 1812.
Default = 1645
Number of seconds to wait for a response from the RADIUS server, in the range 1–60.
Default = 5
Number of attempts to make to authenticate a user after a time-out, in the range 1–10.
Default = 3
Deletes a primary or secondary RADIUS server definition. If a primary server is deleted and a
secondary server was configured, that secondary server becomes the new primary server.
Description
SCS commands 63