Introduction; How To Use This Manual; Equipment Identification; Receipt Of Equipment - CIGWELD WELDSKILL 200HF Operating Manual

2.01 How To Use This Manual

This Owners Manual only applies to the Part Numbers
listed on page i.
To ensure safe operation, read the entire manual,
including the chapter on safety instructions and
warnings.
Throughout this manual, the words WARNING,
CAUTION, and NOTE may appear. Pay particular
attention to the information provided under these
headings. These special annotations are easily
recognized as follows:
!
Gives information regarding possible
personal injury. Warnings will be
enclosed in a box such as this.
Refers to possible equipment damage.
Cautions will be shown in bold type.
NOTE
Offers helpful information concerning
certain operating procedures. Notes will
be shown in italics
Additional copies of this manual may be purchased
by contacting CIGWELD at the address and phone
number for your location listed in the inside back cover
of this manual. Include the Owner's Manual number
and equipment identification numbers.
Electronic copies of this manual can also be
downloaded at no charge in Acrobat PDF format by
going to the CIGWELD web site listed below and
clicking on the Literature Library link:
http://www.cigweld.com.au
Manual 0-5406
OPERATING MANUAL
SECTION 2:

INTRODUCTION

WARNING
CAUTION

2.02 Equipment Identification

The unit's identification number (specification or part
number), model, and serial number usually appear
on a nameplate attached to the control panel. In
some cases, the nameplate may be attached to the
rear panel. Equipment which does not have a control
panel such as gun and cable assemblies is identified
only by the specification or part number printed on
the shipping container. Record these numbers on the
bottom of page i for future reference.

2.03 Receipt Of Equipment

When you receive the equipment, check it against the
invoice to make sure it is complete and inspect the
equipment for possible damage due to shipping. If
there is any damage, notify the carrier immediately to
file a claim. Furnish complete information concerning
damage claims or shipping errors to the location in
your area listed in the inside back cover of this manual.
Include all equipment identification numbers as
described above along with a full description of the
parts in error.
Move the equipment to the installation site before
un-crating the unit. Use care to avoid damaging the
equipment when using bars, hammers, etc., to un-
crate the unit.
2-1
200HF
INTRODUCTION