Stick (Mmaw) Welding; Setup For Stick (Mmaw) Welding - CIGWELD WELDSKILL 200HF Operating Manual

6.01 Setup For STICK (MMAW) Welding

A. Select Stick mode with the process selection control (refer to Section 4.02.4 for further information).
B. Connect the Electrode Holder lead to the positive welding terminal (+). If in doubt, consult the electrode
manufacturer. Welding current flows from the Power Source via Dinse terminals. It is essential, however,
that the male plug is inserted and turned securely to achieve a sound electrical connection.
C. Connect the work lead to the negative welding terminal (-). If in doubt, consult the electrode manufacturer.
Welding current flows from the power source via Dinse terminals. It is essential, however, that the male
plug is inserted and turned securely to achieve a sound electrical connection.
Before connecting the work clamp to the work and inserting the electrode in the electrode holder
make sure the Mains power supply is switched off.
Remove any packaging material prior to use. Do not block the air vents at the front or rear of the
Welding Power Source.
Loose welding terminal connections can cause overheating and result in the male plug being fused
in the terminal
Consult the electrode manufacturer's information for the correct polarity.
Work Lead
Manual 0-5406
OPERATING MANUAL
SECTION 6:

STICK (MMAW) WELDING

!
Set Process
Selection Switch to
STICK WELDING mode
Figure 6-1: Setup For STICK (MMAW) Welding
WARNING
CAUTION
CAUTION
NOTE
240VAC, 15A Mains Supply
Electrode Holder
6-1
200HF
NEGATIVE
OUTPUT
TERMINAL
POSITIVE
OUTPUT
TERMINAL
Art # A-12971
OPERATION