Promise Technology VTrak M500f Quick Start Manual page 16

VTrak M-Class Quick Start Guide
2. To verify the settings, type net and press Enter.
administrator@cli> net
===========================================
CId Port Type
===========================================
1
1
1
3. Type the following string to set the iSCSI Port IP address and other settings,
then press Enter.
administrator@cli> net -a mod -t iSCSI -p 1 -s
"primaryip=192.168.10.88, primaryipmask=255.255.255.0,
gateway=192.168.10.3"
If you prefer to let your DHCP server assign the IP address, type the
following string, then press Enter.
administrator@cli> net -a mod -t iSCSI -p 1 -s "dhcp=enable"
4. To verify the settings, type net and press Enter.
administrator@cli> net
===========================================
CId Port Type
===========================================
1
1
1
5. Repeat steps 3 and 4 to set the other iSCSI port. Use -p 2 in place of -p 1.
This completes the Management and iSCSI port setup. Go to "Step 8: Install
iSCSI Initiator on the Host PC" on page 24.
To see the full set of CLI commands, at the admin@cli> prompt, type help and
press Enter.
IP
1 Mgmt 192.168.10.87 255.255.255.0 192.168.10.3
1 iSCSI 0.0.0.0
2 iSCSI 0.0.0.0
IP
1 Mgmt 192.168.10.87 255.255.255.0 192.168.10.3
1 iSCSI 192.168.10.88 255.255.255.0 192.168.10.3
2 iSCSI 0.0.0.0
Mask
0.0.0.0
0.0.0.0
Mask
0.0.0.0
16
Gateway Link
Up
0.0.0.0 Down
0.0.0.0 Down
Gateway Link
Up
Up
0.0.0.0 Down