Cisco MGX 8850 PXM45 Release Notes page 97

Table 29
DDTs Issue
CSCdy82219
CSCdy82305
CSCdy82328
CSCdy82452
CSCdy82780
CSCdy82800
OL-2914-01 Rev D0, July 3, 2003
Severity 3 Open Caveats for MGX 8850 3.0.10 Software (continued)
Description
Hardware:axsm1b_oc3
Symptom: PNNI ports go into provisioning mode and spvcs fail when fault on active
card or card switchover allowed to standby card with fault.
Condition: Utopic 2 Bus CBC to ATMIZER bit tx/rx errors inserted on active or
standby cards.
Workaround: Unknown.
Hardware:axsm1b_oc3
Symptom: PNNI ports went down in progress and SPVCs failed when fault injected
on active or switchredcd allowed to card with fault present.
Condition: Hold ATMizer in reset mode (SWB9) Fault Insertion test case inserted on
active or standby card.
Workaround: Unknown
Hardware:axsm1b_oc3
Symptom:After FS clear K2 was carrying previous channel number for four frames
leading to random behavior of other equipment.
Condition: Initial condition:WS2 is primary and active line is WS2 Issue FS Issue FS
clear. Active line and Primary section shall be WS1, and mismatch should not occur
on either node.
Workaround: None.
Hardware:axsm1
Symptom:QE48 fault not detected in standby state.
Condition: User executed QE48 VC Table and QDB Memory Bank Fault Insertion
test cases.
Workaround: Unknown.
Hardware:axsm1
Symptom: Faulty card did not reset and come up as failed.
Condition: Customer executed QE48 Tx UTOPIA3 to Humvee parity error fault
insertion test case.
Workaround: Unknown.
Hardware:axsm1
Symptom: Card with fault inserted came up as standby.
Condition: Customer executed HUMVEE to SPEEDUP PLD UTOPIA 3 parity error
fault insertion test cases.
Workaround: Unknown.
Release Notes for Cisco MGX 8850 (PXM45), MGX 8850 (PXM1E), and MGX 8830, Software Release 3.0.10
Caveats
97