About Release 3.0.10; Type Of Release; Locating Software Updates; Release Note Document Changes - Cisco MGX 8850 PXM45 Release Notes

Multiservice switches
Table of Contents

Advertisement

About Release 3.0.10

These release notes describe the system requirements, new features, and limitations that apply to
Release 3.0.10 of the MGX 8850 and the MGX 8830 multiservice switch. These notes also contain Cisco
support information.
Release 3.0.00 introduced the MGX 8850 (PXM45) to both PNNI scaling via an enhanced connection
count (up to 250K connections) and IP/MPLS scaling with the MGX-RPM-XF-512. Release 3.0.10
strengthens the low- and mid-range MGX routing nodes (PXM1E and PXM45) through an increase in
the available T1/E1 ATM port density with a 16-port card for the PXM1E and a 32-port card for the
PXM45, both with IMA capability.
These release notes accompany the technical manuals listed in the
page
For information about MGX 8950 Release 3.0.10, see the Release Notes for Cisco MGX 8950 Software
Release 3.0.10.

Type of Release

Release 3.0.10 is a hardware and software release for the MGX 8830 PNNI routing switch.
Release 3.0.10 is a hardware and software release for the MGX 8850 (PXM1E) switch.
Release 3.0.10 is a hardware and software release for the MGX 8850 (PXM45) switch.

Locating Software Updates

Software updates are located at Cisco Connection Online (CCO) at the following location:

Release Note Document Changes

These changes have been made to this document since the Rev. B0, October 24, 2002 revision.
OL-2914-01 Rev D0, July 3, 2003
108.
http://www.cisco.com/kobayashi/sw-center/wan/wan-planner.shtml
Fixed typographical errors.
Removed non-supported SRM-3T3/C card from hardware tables and from Limitations section.
Added the caution about replacing T1 or T3 cards with E1 or E3 cards (or vice versa) to use the
clrsmcnf command.
Added syntax for enableaxsmbaps command to clarify usage.
Added limitation about when configuring virtual interfaces on AXSM cards, that the physical
interface must be of the same ATM header type.
Added missing SMB-4-155 back card for the AXSM-8-155-E front card.
Release Notes for Cisco MGX 8850 (PXM45), MGX 8850 (PXM1E), and MGX 8830, Software Release 3.0.10
About Release 3.0.10
"Related Documentation" section on
3

Advertisement

Table of Contents
loading

This manual is also suitable for:

Mgx 8850 pxm1eMgx 8830

Table of Contents