Cisco MGX 8850 PXM45 Release Notes page 89

Table 29
DDTs Issue
CSCdx67417
CSCdx81165
CSCdx82847
CSCdy09657
CSCdy10115
CSCdy10480
OL-2914-01 Rev D0, July 3, 2003
Severity 3 Open Caveats for MGX 8850 3.0.10 Software (continued)
Description
Hardware: all
Symptom:
Conditions:
Workaround:
Hardware: axsm1b_oc3
Symptom: Slot 11 does not send out AIS for DAX or Non-DAX SPVCs.
Conditions: When slot #11 is the active slot
Workaround: None.
Hardware: pxm1e
Symptom: line status LED's on standby pxm1e always show green
Conditions: The line status LED on standby PXM-1E always show green even if the
line is in LOS. This is inconsistence with other LEDs on PXM-1E. e.g. the ALARMs
LEDs on the standby PXM remain OFF. We think that the line status LED either
reflect same as of active PXM or they remained OFF as of alarm LED. (On PXM-1
they remain OFF on standby PXM)
Workaround: None.
Hardware: pxm1e
Symptom: dspdiagstatus does not display the state and role of SM's; It displays the
info only for the PXM1E and SRM cards.
Conditions: PXM1E dspdiagstatus command does not display the state and role of
SM's where as same command displays the state and role in MGX-45. In case of a
PXM1E node, the role and state info for SMs should say N.A (or something similar
to indicate that NBSMs status is not displayed by this command)
Workaround: None yet. Currently, "Idle/Unknown" is the role/state combination that
is used to indicate that diags status does not apply to SMs. This will be changed soon.
Hardware: pxm45
Symptom: Spurious event log messages for environmental alarms for DC supply are
logged.
Conditions: Unknown.
Workaround: None.
Hardware: pxm45
Symptom: Default 0 SCT is not shown for FRSM-12-T3E3.
Conditions: Execute dspscts/
Workaround: The system will allow the user to configure port and card level SCTs
even though the display does not show it.
Release Notes for Cisco MGX 8850 (PXM45), MGX 8850 (PXM1E), and MGX 8830, Software Release 3.0.10
Caveats
89